H-20 Control

Ethernet protocols in a conveyor environment can be difficult due to the number of control modules in a system. Hilmot has solved those issues using H-20 control.


Hilmot H-20 Control consolidates EthernetIP nodes using 1 Ethernet handshake reducing overall costs.

  • Reduction of hardware 

  • Reduction of Ethernet cables – one per card – cost saving in cabling

  • No network switch needed

  • Reduction of EthenretIP master devices

  • Reduction in labor, installation and programming costs


The H-20 control module is a two-zone controller that has a smaller footprint and can fit almost anywhere including curves and spirals.   


The H-20 has built-in cables eliminating the need for the sensor, motors, and extension cables, etc. compared to a four zone controller. 


The H-20 Control maximizes usage per card because a two-zone controller proves to be more flexible and minimizes unused zone control.


Management of cables is much easier because it is built into the side frame design.


AS-Interface cables can be inserted or removed from the drive cards quickly even while powered up. No removal of hardware necessary.


H-20 control modules are tool-less making them easy to remove or replace,


Full control and visibility of all field devices.






Products Required:

-H-20 Two Zone Control Module

-H-20 I/O Module

-H-10 I/O Module

-AS-Interface Double Gateway

-AS-Interface Handheld Programmer



Software and Commissioning Tools

Full Control - Function Blocks Online

ASI Analyzer 

Inquiries? Go Here

  • LinkedIn Clean
  • w-facebook
  • YouTube Clean
  • Twitter Clean

Shop The Hilmot

E-commerce Store

Hilmot, LLC | 11925 W Carmen Ave Milwaukee, WI 53225  | 414-446-4900

© 2019 by Hilmot LLC