Hilmot's divert modules are offered in tri-directional or bi-directional models. Bi-directional modules have one 30° spur mounted in either the right hand (RH) or left hand (LH) divert position. Tri-directional modules have two 30° spurs mounted one on each side. Two divert rates are available, low speed (20 cases per minute) or high speed (30 cases per minute). The internal divert mechanism has been cycle tested at 1 million cycles. The mainline divert module is 90", 108”, and 144” long and available in Hilmot's standard widths: 15", 18”, 21", 24", 27", 30”, 33” and 36" widths. The 7-1/2" deep side channels on both the spur(s) and the bed continue the same Hilmot profile. Cable trays are utilized for routing wire within the bed frame. Drive rollers are grooved to accept hi tensioned urethane O-rings to transmit the torque to the idler rollers that complete the zone length. The idler rollers are made with flow coat galvanized tubing.

 

  • Built-in photo eye, one per zone

  • Pre-wired, networked with bus technology

  • Motorized rollers 24VDC brushless, geared or gearless

  • Shroud or fascia

  • PLC- or PC-based control or platform

  • Precision bearings in the idler rollers

  • 75 lb Capacity

Divert Module

Series 1000 - Standard MDR
Show More

Inquiries? Go Here

  • LinkedIn Clean
  • w-facebook
  • YouTube Clean
  • Twitter Clean

Shop The Hilmot

E-commerce Store

Hilmot, LLC | 11925 W Carmen Ave Milwaukee, WI 53225  | 414-446-4900

© 2019 by Hilmot LLC